Split Repair Boot that is large enough to encapsulate most large sized entry fittings. SBXXL8.8x6.8x4.6, SBXXL8.8x6.8 & SBXXL8.8

ENCAPSULATION INSTRUCTIONS

ENCAPSULATION INSTRUCTIONS

Split Repair Boot that will encapsulate small entry fittings. SBL2.5, SBL3.5 & SBL4.5

Low Profile Split Repair Boot that is designed to replace an existing 8 studded entry fitting. This boot has a total height of 2.25”. SBL3.5LP

Split Repair Boot for dual supply/return lines for generator sites. SBL4.8x1.9x1.4

ENCAPSULATION INSTRUCTIONS

Split Repair Boot for applications where there is no fitting installed. SBM3.5, SBM2.5 & SBM2.0

ENCAPSULATION INSTRUCTIONS

Split Repair Boot that is designed to replace an existing 4 studded entry fitting or where there is no fitting. SBS4B1.4

Split Repair Boot that is designed to replace an existing 4 studded entry fitting or where there is no fitting. This fitting has a 60 degree angle molded into the boot to enable it to accommodate repairs where the conduit is entering the sump at up to 40 degrees. SBS4B1.4ANGLE

Split Repair Boots used inside the sump to repair Total Containment Bulkheads and Conduit Penetrations. Repair boot threads directly onto existing bulkhead. Fittings can also be used to seal off ducting to allow re-pipe with double wall pipe.

The SR Series Pellethane Split Repair Reducers and Test Reducers are used to replace failed and deteriorating secondary test boots without breaking the main lines. All boots come with band clamps and are available with and without air test valves. 

PART NUMBERS & PRICING

The SI Series Pellethane Split Repair Inserts are used for the SB and SR Repair Boots to reduce down to any pipe dimension.